7 posts • Page 1 of 1
Went on vacation and came home to a no crank no start. checked started/solenoid, all fuses and relays, replaced ignition switch and still no luck. I can however, jump the starter relay block and get the car to start. Once the car is started all trouble lights are on (wrench, check engine, air bag, traction control). the car is throwing codes p0155, p0135, p403, p443. car has 220,000 miles. Any idea on what to check would be appreciated! I'm going crazy trying to figure out whats going on! Thanks!!
Does it run ok?
It sounds like something big in the computer system went wrong check all the wiring harnesses especially the one going to the PCM behind the power steering reservoir it can rub through the wires on the ac line watch this video https://www.youtube.com/watch?v=IrDL810CEI4
the car sounds fine once its started, but when shifting out of park it slams into gear, and seems to be in a limp mode when moving. I only drove it 20 ft in the driveway and decided to get it back in the garage while i still could. I checked that rubbing spot you suggested but on my freestyle it doesn't touch that AC line. Any other suggestions of rubbing points to look into?
Check fuse #41 under the hood:
2006 SE Silver w/Slate cloth
Maybe the PCM Is shorted those 4 codes all together seem to be a big red flag for the PCM I looked up all those codes in 1 search and there seems to be a lot of forums where people say the PCM is bad
that is what my research said as well. But before I attempt to replace the PCM i wanted to make sure i have checked all my grounds. Any Idea where i can find all of them? I have the three by the driverside front wheel well and band by the passenger wheel well.