3 posts • Page 1 of 1
I have been using a 2005 year model of ford freestyle limited edition. For no apparent reason, lots of errors appeared on the dash such as AWD malfunction, ABS error, Traction control and many many error messages. Then we removed the DEM and found out after removing the solenoid that the board in the DEM is burnt. However, I've gotten a new DEM but would want to know from fellow friends that must the DEM be programmed after a replacement with a new one?
i wonder who "Voodoo Bob of the Dead Poets Society" is hounding now.....
Thanks very much. My only fear was not to have the DEM blown again because it quiet expensive and the original one was actually damaged by a mechanic. However, I have already have it fixed but have not connected the plugs that goes to it which is the power and that of the motor. I shall give it a trial but does that mean if I connect it all the errors too will clear and revert to its normal state and performance?